Need parts for Victor Regulator

[gsdavis1]

I just picked up a set of used torches. Worked fine for a while but now I need a new diaphram for my Oxy Regulator. It is a Victor SR5. I have searched the internet and have come up dry for any parts suppliers. The locals have proved themselves to be unhelpful too. Maybe there is not enough profit in it for them. Anyone have any leads?

Greg

[JamesBrauer66]

I found this place a while back, but have never ordered anything from them. Let me know how they are if you order anything, I need some O-rings for my cutting torch.

http://www.regulatortorchrepair.com/store.php?crn=66&action=show&show_products_mode=cat_click

[Rich59]

I have ordered parts for torches and regulators form these people. Great service and very helpful with finding hard to get parts.

They have been good about telling me when they think I would be better off to just replace a torch or regulator even though that cost them the sale of repair parts.

[weldingprof]

You should leave the repair to a "certified" tech! When dealing with pressures over 2000PSI it would be wise to let someone who is qualified do the work. Take the regulator a vendor and have it sent to a repair station or send it back to Victor. Just like SCUBA regulators a person must be certified in order to disassemble, repair and reassemble these types of regulators. Standard operating pressure for an O2 regulator is approx. 2250 psig. Presures can and do exceed 2500 psig...don't mess with fire.