Jackstand modification - slip over covers

[Jon K]

Couldn't stand how these jack stands were sitting into the car jack points so I needed something w/ more of a flat surface than a lipped surface for this particular vehicle. So, I boxed in the jack stand end and TIG'd it up.

http://farm9.staticflickr.com/8009/7274348316_981273ba3b_z.jpg (http://www.flickr.com/photos/67031861@N08/7274348316/)
Jack stand covers (http://www.flickr.com/photos/67031861@N08/7274348316/) by Jon Kensy (http://www.flickr.com/people/67031861@N08/), on Flickr

http://farm8.staticflickr.com/7227/7274367814_f89c7a2a25_z.jpg (http://www.flickr.com/photos/67031861@N08/7274367814/)
Jack stand cover (http://www.flickr.com/photos/67031861@N08/7274367814/) by Jon Kensy (http://www.flickr.com/people/67031861@N08/), on Flickr

Not amazing welds and I didn't clean up the metal before welding - not going to win any awards, I just needed to get this car off the ground so I can drop the rear out.

[LarryO]

I have some HD rubber that i cut to fit between the lips. Non scratch and flat.

Hey, i also heard those Sumitomo tyres will not be available for much longer. Plant shut down.

[Jon K]

I have some HD rubber that i cut to fit between the lips. Non scratch and flat.

Hey, i also heard those Sumitomo tyres will not be available for much longer. Plant shut down.

Poop - I will need to find another cheap tire to burn up :)

[dumb as a stump]

Perhaps cut some tire tread (found on side of highways) for anti scratch of paint on the car. Perhaps glue it on? Good idea though.

[VPT]

I just throw a rag over the top of jacks, jack stands, or the lift arms to protect paint.