RickLinstad
06-16-2004, 09:42 AM
Don't know if this should go here or in the HF section, but this seems as good a place as any.
Saw this right angle jig made for holding two pieces at a right angle for welding and the price was right (about 10 bucks). Looked pretty good when I got it home.
When I put a couple of pieces of wood in to check how square it was, I found it was off by about a quarter of an inch in 12 inches. Not exactly what I had hoped. Good think HF has a good return policy.
Has anyone tried one of these? Is there something I'm missing? There are two scews on each pad that I have no idea what they are for. Is there some easy tune up to get this thing useable?
Thanks.
Rick
Saw this right angle jig made for holding two pieces at a right angle for welding and the price was right (about 10 bucks). Looked pretty good when I got it home.
When I put a couple of pieces of wood in to check how square it was, I found it was off by about a quarter of an inch in 12 inches. Not exactly what I had hoped. Good think HF has a good return policy.
Has anyone tried one of these? Is there something I'm missing? There are two scews on each pad that I have no idea what they are for. Is there some easy tune up to get this thing useable?
Thanks.
Rick