Miller welder overhaul job

[Robert D]

This is a miller that iam rebuilding...going on 2 years now...evertime I start ...I find a new projuct...My mind is starting to forget how it all goes...Does anybody have a instruction book? or just wing it :}

[Robert D]

2nd

[Robert D]

last

[Franz]

I hope you knew the electric end of the machine was good before you started rebuilding. I have 1 with a good engine and a BAD rotor that I need to get pulled apart.
I don't think the manuals are available on line for Roughneck, but I do have the direct # here for the guy at the factory who knows them inside and out if you need it.
I also have a dealer who has a few of them in the back room for parts, so I think I can get a good rotor for mine. Since I have a Bobcat, the roughneck is kind of a back burner project.

[NoDak]

Robert D

If you go to www.Millerwelds.com home page under service & support select owners manuals. You can down load them or request a printed copy. Need model and serial number. It looks like they have them listed going back many many years!

Hope this helps.

[Robert D]

Thanks for the info