hobart 140 needs a new liner

[92f150300six]

ok i have a problem i bent the liner in my 140. so now i have to fix it but how? and how much do they cost. i have a warranty on it but i really dont want to ship it out wate and get it shiped back. i dont know if hobart will just ship me the part and i fix it or not

[duaneb55]

ok i have a problem i bent the liner in my 140. so now i have to fix it but how? and how much do they cost. i have a warranty on it but i really dont want to ship it out wate and get it shiped back. i dont know if hobart will just ship me the part and i fix it or not

92f150300six (so whataya drive?):rolleyes:

Assuming it's a Handler 140 and H-10 gun, here's the manual http://www.hobartwelders.com/om/0900/o925d_hob.pdf for the unit that addresses liner replacement on page 26. I don't think a kinked liner is covered under warranty but they're only $10-12 tops.

Duane

[92f150300six]

thanks alot . and it was page 30. man i thought i would be a bit harder than that. and as for the warrnty when i bought i got a special one and they told me . if anything broke even if it was my doing they would fix it that kinda sealed the deal.plus if the same thing goes wrong with it 3 times or more the give me a new welder.its been a great welder but all ready wanting to up grade. and set this one up for auto body panels only.and get a a hh210 for my bigger stuff.

[duaneb55]

Page 30 of the .pdf file - page 26 of the actual document but who's counting?:D

Sounds as though you got a really good deal if they'll even cover problems that result of user actions. Personally I wouldn't send it back for a liner though and I'm sure that's what the seller was banking on too.;)

Duane

[tapwelder]

If you end up doing it yourself, then get two liners. No need for down time. It is good to have spare consumables.

[92f150300six]

tap thats a great idea.how much are the nylon linners will they still kink