View Full Version : Need wiring help on an Apache D.C. 150 amp welder

06-26-2005, 11:57 PM
I have an Apache model 150 D.C. Arc Welder. It has a 13hp Briggs and Stratton motor turning a delco car alternator. It was made by Siebert Equipment Corporation, Santa Ana California.

There is a blue wire that is coming off the circut board, it came off from somewhere and I can't find out where it goes back on. Does anyone have either a wiring diagram for the Apache 150 amp welder or know where this blue wire should go?

Thanks in advance,