Any old Hobart boards?

[rpmmillwright]

Hello All,
I am looking for a voltage regulator board for our old hobart GCC-510. It was a common board at the time. Ours exploded somehow when someone was messing with the machine. I have everything but that board up and working again. The part # is 355894A-2
If anyone has or knows of one let me know please.
Rick

[mudbugone]

You might want to explore the Hobart site http://www.hobartwelders.com/weldtalk/ If it can be found or perhaps repaired someone might have some information that helps.

When looking for that kind of stuff,you can't contact too many sites for help...Good Luck.

[rpmmillwright]

Been there allready a member. In fact that is how I was referanced to this board. Thanks

[metalworker]

Also you can try on http://welderzone.com

[7A749]

Hello All,
I am looking for a voltage regulator board for our old hobart GCC-510. It was a common board at the time. Ours exploded somehow when someone was messing with the machine. I have everything but that board up and working again. The part # is 355894A-2
If anyone has or knows of one let me know please.
Rick

I unfortunately do not. I do happen to have a BUTT LOAD of wire feeder wheels & drive gears for Hobart feeders tho. Many in package NOS. I have a plastic tote about half full with Hobart wire feeder stuff. I bought a large lot of Miller wire feeders & this stuff came with it.

PM me if you have an interest.

[lars66]

Weldmart might have some parts or C&M at 419-584=0008.

[duaneb55]

Check with the fine folks at Arc Products http://www.arc-products.com/. Ask for Josh.

[zapster]

Check post #8...
I have been to his place...
This guy will have it no problem..

http://weldingweb.com/showthread.php?t=14868&highlight=polarity+switch

...zap!

[LarryO]

.........