Hi everyone. New here

[jcooper]

I found the site looking for projects on google. I have found a lot of good info here. I have a stick welder and a campbell hausfield 125 mig. Not to exprienced but have laid a few beads. I like rebuilding old mini bikes and will be looking to build a few of my own. I have just completed a 30x50 pole garage. The doors should be on by this time next week. Lots of shop room. I'll be looking to building a welding table and liked some of the pictures that I viewed on the projects page. I'm sure I'll have a lot of questions as it gets closer to winter here in Ohio.

Can anyone suggest a pipe bender that won't flaten the pipe at bends at a reasonable price. Keep in mind that cost is a factor. Any links or pictures would be great.

Nice to meet everyone.
jcooper

[paul guthrie jr]

welcome aboard!:waving: as far as the bender goes...i would also love to find a reasonably priced one.

[TEK]

:waving: :waving: :waving:

[shadetree]

Try Harbor freight ain't great give it a whirl

[fallon416]

If you fill the pipe with sand and cap the ends before bending it won't crush.