Newbie Greg here with a quick question....

[greg5003]

It's about my weld pack 100. I forgot but the man took off two wires off of the gas solenoid. I see on the circut board were they go.There is a spot that says H2 and H1 control. Does it matter which wire goes were or can I hook them up and just go. Appreciate all the help.Greg

[DesertRider33]

I would just hook them up and go. If it stays on when it's supposed to be off and vice-versa, then swap the wire positions.

[Sandy]

Hey greg, pick your manual here; http://www.mylincolnelectric.com/Catalog/lecooperatorsmanualsearch.aspx

You'll need the manual for a lot of little things anyway.

[stockcar92]

the solinoid has no polarity meaning that either wire can go in either spot. it does not matter which way the current flows in the coil the result will be the same. it will induce a magnetic feild the will open the valve.

[ed mac]

i have the installation instructions for the weld pak 100
mig conversion kit from 1/15/93 i can email you a copy