Bob at WeldingMag
06-22-2006, 03:50 PM
All,
The June issue of Welding Design & Fabrication magazine is now online. You can get to by clicking the "Home" button on the maroon menu bar at the top of this page.
Or this URL will take you directly to the issue's online contents page: June issue. (http://www.weldingdesign.com/323/WDF/Issue/2042)Content includes:
+ How to increase a fillet weld's strength without a proportionate increase in weight, by weld engineering legend Omer Blodgett;
+ An interesting piece on tunnel boring machines -- how these giant units are built to withstand the tremendous stresses they must tolerate;
+ Choosing the right abrasive for the right prep job;
+ The high cost you might ultimately pay when you buy low-cost GMAW wire.
The June issue of Welding Design & Fabrication magazine is now online. You can get to by clicking the "Home" button on the maroon menu bar at the top of this page.
Or this URL will take you directly to the issue's online contents page: June issue. (http://www.weldingdesign.com/323/WDF/Issue/2042)Content includes:
+ How to increase a fillet weld's strength without a proportionate increase in weight, by weld engineering legend Omer Blodgett;
+ An interesting piece on tunnel boring machines -- how these giant units are built to withstand the tremendous stresses they must tolerate;
+ Choosing the right abrasive for the right prep job;
+ The high cost you might ultimately pay when you buy low-cost GMAW wire.