Miller Spoolmate 3035

[zukinoobi]

I have a MM210 with a 3035 spoolgun. I'm tired of switching spools to change wire sizes.

I run .030 normally but want to be able to run .023 for some light body work. Changing spools is becoming a drag and, since I don't run much aluminum, my spoolgun sits idle most of the time. With the right parts I could have both guns sitting at the ready with different dia wire.

I would like to run .023 in the spoolgun but my local suppliers say they will have to special order the drive wheels for that diameter wire and it could take several weeks after an order is placed before I get my parts. Horsefeathers!

I'm hoping someone knows a distributor who stocks these parts and maybe even could accept orders over the internet.

#199 730 .023 contact tips
#199 732 .023 drive roll
#199 732 .023 push roll

TIA

[Doolittle]

Did you try cyberweld?

[zukinoobi]

Did you try cyberweld?

Thanks, Doolittle. I'm not familiar with them - I Googled them and checked the Miller section. I see feed and push rollers but not by size or part number. I guess I'll try giving them a call tomorrow.

Any other suggestions?

[DDA52]

Try these guys.


http://www.miller4less.com/

[zukinoobi]

Thanks! I just sent them an email! Here's hoping!:)

[DDA52]

No worries. I looked up the numbers..they do list them there. Now as to whether they are in stock or not........:confused: Miller is usually pretty good about getting parts out, except when they are on back order. Been waiting on a gooseneck for 4 weeks now.:rolleyes: