I had an issue with my 1/2 inch thick welding/layout table - ended up warping it from too much heat. Short story - in involved too much thinking fluid being applied to the operators.

Anyway, I have been looking to upgrade and found this the other day. 1" thick - 49" x 86". 4x6x1/4 legs and 4x4x1/4 angle for the cross members.

Plate weighs just short of 1200#, it should work for the long haul. I kept the old table so I can run long pieces across the two.

Name:  New Table 1.jpg
Views: 60
Size:  107.7 KB[ATName:  New Table 4.jpg
Views: 63
Size:  101.7 KBTACH=CONFIG]1690095[/ATTACH]Name:  New Table 2.jpg
Views: 60
Size:  89.9 KBName:  New Table 4.jpg
Views: 63
Size:  101.7 KB