Tap tap. Is this on?

[Jay Trainor]

Yes, hey out there.

Not much to say here until I read the stickies and see if this is the right place to get my questions answered.

Hope to post up screen shots of project by tomorrow.

Anybody with W14 or W16 experience can look in and call out any concerns, problems, limitations, options, or references on truss designs, bolts vs. welds, cuts, etc.

Need to prep design for meeting with structural engineer, then with local welder.

For my part I am outta my league, having only 5 years with a small MIG. Have used new Victor Gas Torch set up only for cutting lighter gauges.

More later maybe