Brand new Dynasty 200 DX, how to power the coolmate?

[Acidrain]

If you were following my other thread about the 300 DX with no HF start, and low power, that thing turned out to be too much work to fix, so...
I bought a brand new 200 DX. The thing is, my 300 had a 110v plug in the back to power my coolmate torch cooler, but the 200 doesn't have that.
What are you guys doing?
I've gotten really used to using one switch for both, and have already forgotten to turn on the coolmate while welding.
Is there a switch that will turn on both the 240v welder and the 110v cooler?

[SundownIII]

acidrain,

Have the same issue. Don't know of a single switch for both 240 and 120v power.

Don't worry though. A couple burned up power hoses (which dump your coolant) and possibly take out the gas hose and it's amazing how your "memory" will improve.

I actually made a little cover (put on with double side mounting tape) over the power switch on the back of the Dynasty. Says "Turn On Cooler".

[BD1]

Here's the Miller site . They have a dedicated thread on the Dynasty

http://www.millerwelds.com/resources...ng-Discussions

[Drf255]

Originally Posted by SundownIII

acidrain,

Have the same issue. Don't know of a single switch for both 240 and 120v power.

Don't worry though. A couple burned up power hoses (which dump your coolant) and possibly take out the gas hose and it's amazing how your "memory" will improve.

I actually made a little cover (put on with double side mounting tape) over the power switch on the back of the Dynasty. Says "Turn On Cooler".

Mine says "turn on the gas" too. It's great when the Aluminum looks like a sparkler and you realize you never turned the gas back on.

I run 2 extension cord to my tig runner and I agree, its a bit of a PITA.