Curved stairway round two

[buggyboy_2006]

Well we had to take the first one apart, the channel for the stringers wasn't bent right so our stairs didn't fit and we didn't have enough reveal on the steps to make code. here are three more crappy phone pics. I almost finished it today so I'll have pics of it completed tomorrow (without powdercoating). We cut the stairs on the plasma table and bent them ourselves, but we had the stringers bent for us. I found out a little about it, they run the channel through three rollers. We made wood templates for them to go by as this was the 4th time they bent em lol and we needed them right. They also rolled all the steel for the lower, upper and cap rails. I cut all the pickets, did all the drilling/setup/welding. The only thing I didn't do was set up the plasma table as I haven't been trained on it yet. Not bad for being a welder for all of 8 months or so? Any criticism welcome (except for my photo skills on a crappy camera phone haha).