Old Syncro 250

[QuestWeld]

Well it has been some time since I posted here but have been lurking quite a bit lately. I recently purchased an older Syncrowave 250. Not a bad deal for everything that was included... weldcraft wp26, rfcs-5 and stick leads for 1500.00. Not to mention all the other goodies along with it. Too many to list now.

My question is how can I determine if this machine has pfc built into it? It seems highly unlikely that it is because the manual I downloaded shows it to be an 88 model.
Serial is JJ508971
Any help with this will be highly appreciated!

[Broccoli1]

call Miller tech- they'll probably be able to give you an answer over the phone

[QuestWeld]

Thank you Mr Conley! Looking back through the manual today ... I'm thinkin no pfc on this machine. I'll give Miller a call to be sure. I'm just a bit anxious to get the ball rolling and give it a test run. Been a few years since I've had access to a tig and I'm ready to give it a go again! Thank you for your reply!