This goes to a acid bath line somewhere..
MUST be sealed so NO acid gets inside..
Tube is 14" welded seam 304 stainless..3/8" wall..
Heads are .700 thick 304 shrunk in to the tune of .025....These 'aint goin' anywhere..
.045 308 filler..
160 amps MAX with the pedal down..
Did these standing up..No positioner..(Too Heavy)..
And now from standing I have a pain in my a$$
The shaft will be installed tomorrow..
I hate it when the holes in the heads are to size with the shaft..
The heads were salvaged from the original roller..
Now comes the test of how good I did indicating in the bores so I could do the OD of the heads...
I am not completely insane..
Some parts are missing
I have figured out that keeping everyone happy is nearly impossible but pissing people off is easy and fun.