View Full Version : Looking for job in NC

rajun asian
06-01-2007, 05:38 PM
Hello. I live in Statesville, NC. I've been Tig welding for a little over two years now. I do mostly stainless of all thicknesses from 20ga up to 1/4" and occasionally thicker. I also do some cold-rolled steel and a touch of aluminum. I have done a bit of mig welding, but not a whole lot of experience in setting up mig welder for voltage, wire speed, etc.

I love tig welding and make pretty decent money where I'm at, but would just like to get into a shop where it's not always the same old stuff day in and day out.

If anyone has any leads, please PM me or drop me an e-mail. My e-mail address is jguzik@bellsouth.net.

Thanks alot.


rajun asian
02-28-2008, 04:09 PM
Bumpin' this post to the top again. Still looking for a better place to work. I used to work in a shop that does pressure vessel welding in NY which I really enjoyed. It was called " Feldmeier Equipment". Wish they had a branch in NC....I'd be working there now. Would like a place where I can learn some new techniques and weld on a variety of metals. Here's a link to the company I used to work at in case anyone is curious or even looking foe employment. I know that they are ALWAYS on the lookout for good welders and fabricators.




03-02-2008, 01:43 AM
fluor global is hireing in greensboro Nc 2 inch combo pays 22.00 hour 65.00 a day i think

03-02-2008, 01:04 PM
Try this, just put your zip code in.