PDA

View Full Version : Help finding consumables?



bdog_v
07-28-2008, 01:12 AM
--------------------------------------------------------------------------------
Hello so far you guys have been very helpful. I just got my plasma cutter hobart Airforce 400 today and haven't had a chance to use it yet so I can't ask any ?'s on using it but

-I am wondering what is the best place to buy consumables online or do standard hardware stores carry them?


-Which consumables do you tend to use up the fastest or what should I stock up on that'll wear out first?



-It looks like the only consumables I can find are also for the Miller brand, do the two interchange on most parts. I can't find anything specifically for the Hobart?


Thanks a ton!!!

Broccoli1
07-28-2008, 05:25 PM
http://store.cyberweld.com/icpltopa1.html


ICE-27C plasma torch comes standard with the Hobart AirForce™ 400.


Miller and Hobart use the same Torch.

Broccoli1
07-28-2008, 05:32 PM
--------------------------------------------------------------------------------
-Which consumables do you tend to use up the fastest or what should I stock up on that'll wear out first?


http://store.cyberweld.com/tip27amp176656.html

http://store.cyberweld.com/electrode27amp.html

Those 2 will go the frst.

And make sure you have a good system to keep the water out of the line from the Compressor.

aametalmaster
07-28-2008, 09:22 PM
Just ask for Jeff...Bob
http://www.usaweld.com/products/plasma_torch_parts/index.htm