Intermittent High Frequency on Syncrowave 200
RSS | Subscribe | Contact Us | Advertise | About Us
Results 1 to 2 of 2
  1. #1
    Join Date
    Sep 2009

    Intermittent High Frequency on Syncrowave 200

    I have seen this problem before, but it cleared quickly. Now HF is missing most of the time. I can hear the gas solenoid click, so the pedal is good.

    I am not really sure where to start looking for a problem like this. Do I pull off the covers and get out a heat gun to see if I can figure out where the problem is? I should check the point clearance, I assume.

    Thanks in advance for your thoughts.
    Sculptures in copper and other metals

    Syncrowave 200
    Millermatic 211
    Readywelder spoolgun
    Hypertherm 600 plasma cutter
    Thermal Arc GMS300
    Victor OA torch
    Homemade Blacksmith propane forge

  2. #2
    Join Date
    Jul 2008

    Re: Intermittent High Frequency on Syncrowave 200

    I'd start with cleaning and gapping the HF points. If they need to be dressed, I use 1500 grit paper. A bigger gap will generally make for more reliable arc initiation.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
RSS | Home | Penton Media | Contact Us | Subscribe | For Advertisers | Terms of Use | Privacy Statement