I have a question pertaining to the 230V 20A circuit that I'm installing for my Miller 150 TIG. I'm using a hubbell HBL2323 twist lock plug and I'm concerned about getting the polarity right. The breaker does not indicate which pole gets the white or black wire so does it matter in this case? The reason I'm asking is that the table on the plug package indicates this;
White screw; Grounded circuit connector, neutral (white or grey)
Brass/Black screw; Ungrounded curcuit connector (NOT white, NOT green)
Of course I have the bare wire from the recepticle/box to ground in the breaker panel, and since the white does not go to common, does it matter what the orientation of the white & black wire are?
Thanks in advance
White screw; Grounded circuit connector, neutral (white or grey)
Brass/Black screw; Ungrounded curcuit connector (NOT white, NOT green)
Of course I have the bare wire from the recepticle/box to ground in the breaker panel, and since the white does not go to common, does it matter what the orientation of the white & black wire are?
Thanks in advance
