Hey Guys,
I didnt know where else to post this...
A few weeks ago, a gentlemen called me wanting new Gaurd / Hand Rails. He wanted me to make new Rails, with the same style and look of the old ones. The old Rail Post were rotted out. So I simply used a grinder with a cutting wheel and cut the post flush with the concrete slab. Now the Rails are done. I am going back tomorrow to remove the Slugs (Post) from the concrete. Im assuming they are 3"- 4" in the concrete. (1"X1" 11ga post) I was planning on using a 1/2" Masonry bit and drilling a series of holes around the Post and using a pair of Channel Locks and wiggling them out? Is there a easier or faster way to remove these post? I cut them flush with the concrete (Not my brightest idea) There is 7 total post.
Any help or advice will be greatly appreciated.
Thanks Don.
I didnt know where else to post this...
A few weeks ago, a gentlemen called me wanting new Gaurd / Hand Rails. He wanted me to make new Rails, with the same style and look of the old ones. The old Rail Post were rotted out. So I simply used a grinder with a cutting wheel and cut the post flush with the concrete slab. Now the Rails are done. I am going back tomorrow to remove the Slugs (Post) from the concrete. Im assuming they are 3"- 4" in the concrete. (1"X1" 11ga post) I was planning on using a 1/2" Masonry bit and drilling a series of holes around the Post and using a pair of Channel Locks and wiggling them out? Is there a easier or faster way to remove these post? I cut them flush with the concrete (Not my brightest idea) There is 7 total post.
Any help or advice will be greatly appreciated.
Thanks Don.
