I am driving myself crazy trying to get TIG weld Aluminum down. I can run a bead on a flat surface but when trying a T joint it all goes to pot. Any suggestions on reading that can help out?:realmad:
jemaddux
What part of the world are you in? Do you have access to a good library; probably a decent number of good books exist, and one or more just might be available there.
I can't think right now of any one book which goes into greater detail and has a good troubleshooting section, too, specifically about your situation. If you don't have any books yet, I'd recommend you start with the Lincoln bible: The Procedure Handbook of Arc Welding
I can't think right now of any one book which goes into greater detail and has a good troubleshooting section, too, specifically about your situation. If you don't have any books yet, I'd recommend you start with the Lincoln bible: The Procedure Handbook of Arc Welding
While you were at the library, did you ask if they had a copy of "Ventura Highway"? 
If I'd known you were in Caulifornia, I don't think I'd have suggested the library....
Although I am curious which old book they did still have; some of them do a fairly good job explaining the basics of OA and Stick welding and basic metallurgy, so might still be worth reading.
If I'd known you were in Caulifornia, I don't think I'd have suggested the library....
Although I am curious which old book they did still have; some of them do a fairly good job explaining the basics of OA and Stick welding and basic metallurgy, so might still be worth reading.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
