I am trying get my Thermal Dynamics Pak Master 38xl going again. I am looking for a power switch # 9-4248 and possibly a solenoid valve # 9-4605.
Another problem I have is the air line for the torch is bent flat where it comes through the top of the machine. I don't know why they didnt put a 90° on the top and then the hose straight off of that. The hose is just tired from being bent back and forth so much and I don't think it is getting full air pressure through it. My question is, can I cut this line and put a 90° bend on with barbed fittings and clamps? Is is a no no to cut this line - are there other things inside that can't be cut? Here is a photo to show my problem.
![Image]()
This is the threaded crimped connection it has now inside the machine.
![Image]()
Another problem I have is the air line for the torch is bent flat where it comes through the top of the machine. I don't know why they didnt put a 90° on the top and then the hose straight off of that. The hose is just tired from being bent back and forth so much and I don't think it is getting full air pressure through it. My question is, can I cut this line and put a 90° bend on with barbed fittings and clamps? Is is a no no to cut this line - are there other things inside that can't be cut? Here is a photo to show my problem.
This is the threaded crimped connection it has now inside the machine.
