Activity Stream

Steel, .065, 1”. Clamp everything as true as you can. It is fairly easy in these sizes to bend back to flat after welding and grinding. After it is...

That is what I want just but i need to wear my hood.

Oh also - use sealant on the tapered threads only, not on flare threads.

Yes that is a flare fitting. One end (screwed into the Tee) will be pipe thread (which goes by several names as you noted; see here). Why use a...

It's not just weld sequencing that you need to worry about. Have you seen this other video from fireball tools? ...

Lol, ok man hose clamps eh? Sounds like I can save a lot of money and time then. Thanks!

I agree - copper it is...if I can ever figure out these adapters!!!!!!!!:angry: This is the fitting that will be on the burner - the maker...

Hey thanks. I think i have a plan. This control panel has a fair amount of equipment behind it to run the spoolgun. I am going to have to add some...

I like Jody's technique of wrapping around the corner before stopping. You don't need to clean the entire weld for a restart, just in the area where...

There are also circuit board repair companies that can fix that for you. Not sure how much that would cost. https://www.qie.com/MILLER/004590

Looks like these guys have one, but it is pricey https://weldingmart.com/miller-electric-current-sensor-004590

I'm not sure what you mean by "water rescue", at least in this context. Not arguing, but what's the reasoning for the chains in addition to the...

Am I correct in saying that the weld has to be thoroughly cleaned before another weld can be stopped or started on the previous? That slag gets...

Good morning and welcome from North Carolina. Lance

You cannot use a square sharp corner architectural tube in anything marine, that tower is next to the water. Corrosion starts in the inside and...

Aluminum moves more and differently than steel, so if you cannot hold it flat and square i would use steel. Just my 2 cents of free advice. Sent...

I would say that's fairly normal for the slag to not sit uniform on top of the weld. Your welds look fairly smooth and overall pretty good. Couple of...

Hi, if you are planning to develop your business in an online environment, I can advise you to take a closer look at email marketing. Email...

It was funny a few months later someone stole that from the warehouse, and I couldn't help but feel some relief, haha, and I hate when people steal...

Yea, that is always a danger as the tools get bigger and stronger. I remember I was putting a hole through a cinder block wall at a music school that...