Activity Stream

Professionally staged to make me look like a real weldor type.... Sent from my iPhone using Tapatalk

Basically the same. Mine's an "older" model that has the bolt flange on it, but other than that... It was a toss-up between the JF#1 burner and a...

:laugh: I’m not sure I believe that’s your shop in the picture. Drops cluttering the floor and sheet goods hastily leaned against a wall and...

I have this 2'x4' table from weldingtables.com with 16mm holes on a 2" grid pattern which can also be used on the diagonal with holes...

Hmmm...well, maybe acetylene is more dangerous than other fuels because of its wider "flammability range" which is apparently from 2.5% to 100%! ...

On the other hand that is also when the change is easiest to sell.

I find for the work I do patterns are irrelevant. But I'm sure it may matter to some who do repetitious production work. Sent from my...

A good source for part inquiries is Stumpf Welding Supplies. Been around since 1952. https://stumpfweldingsupplies.com/ Also Welding Supply...

Harris still has tips and mixers for alternate fuel brazing.

I can relate to " all the functions seem a bit overwhelming" on the Tig side. If one has never Tig welded, there are a lot of functions that might...

DMW cracking is another fabrication issue that can and does result in equipment failure. It usually occurs at the weld juncture where carbon steel or...

When I was a kid, there was a house about a mile away where excavators apparently hit a NG line going into the house and natural gas leaked into the...

Did you remove the one brush from the commutator? Are you doing this with your machine stopped and a 12 volt battery, positive to the right hand...

I don't know how to measure the volume of propane metered through a pilot valve in an antique stove. I'd compare it to a small candle flame, mix that...

SOLVED Bad controller. Thanks for the help guys. The brakes on the trailer were working when I tested them so I knew it was on the truck side.

Many thanks for all replies! Found it from Lincoln after a long phone search by them. Part # S12934-1 $4.19

I say Everlast, best Bang-for-the-Buck you'll find (you're asking this question in a forum full of professionals, they're most often biased towards...

In my work I did use a table with holes. Odds are it is just for sale's of table. Most tables I seen in shops had no holes or round holes and shop...

Oh, markets go up and down well beyond the reaches of American politics. Fuel has been slowly rebounding from last springs lows that happened when...

I teach welding for the company I work for. With demand being what it is for production welders right now, they are willing to take on individuals...

Couldn't you check with local community college welding shop for this? Ours thrives on programs like this and seeks companies looking to coordinate...

Good question. Do you have an example if a table with radiating holes? I presume you are considering a full table of holes?