Activity Stream

I grew up in Honey Grove, lived and worked in Paris after high school.

Thanks for clearing things up for me Vaughn, now I understand where you saying. Still waiting on my pipe, my buddy has been having problems with...

As for Hobart welders, Farm and Fleet, Tractor Supply, Fleet Farm, and Northern Tool usually have them on sale. I bought from Baker's Supply ....

Here are a few sites that have the info on waste oil heater/furnace ...

hey acounrtjester. I would like to know more about your waste oil furnace for melting aluminum do you have plans and/or more pictures of it. how...

You're not the first person to not understand me! :D Like Lis2323 shows in his picture, you've got to have something outside of the forge to...

Another trick an old welder taught me. Grind a bevel & sharp edge on the end of a bastard file. Control the heat while doing so to preserve the...

:drinkup: That's a really well thought out Forge design Lis, were did you get the end caps, are they new pickled pipe covers? Again nice job!...

I had a Westinghouse engine drive that had an Onan. I had a friend that worked at Onan and he traced the numbers on the engine and it was WWII...

Nice welding. If your using pure tungsten, then definitely use 1/8" electrode, with the other types it won't make that much of a difference in short...

This is the beeswax I use, it comes in a pellet form. I melt it down in an aluminum chafing dish in the oven at 325 degrees. It has almost no smell...

The two oldest DC machines I welded with were Lincoln motor generators.

Gee, farmers all had them rigged to a track & hopper rig. manure corn or sawdust was put in a hopper, toted around the barn. These were used in...

Thanks for the inputs. I agree with the use of the 1/8" Tungsten and normally that's what I would use for 1/4" and normal torch config. I had been...

... And we're done. Must be a record...

If thinking before we speak was the law on this board, you wouldn't be allowed on the board. You always been one of stupidest members here, with...

Come on now... You were doing so good with this project don’t screw it up now. Take it apart and clean it. But if you want to Try firing...

I think the limited edit time is fantastic. Often times it shows just how stupid/hotheaded/racist/or uninformed certain people are. So let’s...

tackit here is a pic of what I made for my propane forge. It is a horizontal 2" receiver with telescopic work rest for "long" material. ...

Welcome Sent from my LM-X420 using Tapatalk

Vaughn thanks for taking the time to offer your helpful comment, but I don't understand what you meant when you said "holding up anything over a...

thinking MQ Wisperweld ran Isuzu engine

I've always found the "no bending over" rule makes the forge just a little too high for things. Figure, my forge sits on top of 3 layers of fire...