Activity Stream

insurances...omg this is the case when you have to read each small letter and sometimes even between words. How did you solve the situation?

puh, a lot of great information. thx for sharing guys

I use Black Pipe. Keep the runs slightly pitched so water can run to a low point and be drained. I have a copper system only because I started with...

If I could find a Charpy rated flux core in a small enough diameter for my machines, I'd probably run it more. I do know it's a doggone huge bit...

It's hard to weld ANYTHING with the nasty stuff:D Actually....................I'm lying:laugh: It's a damn sight more forgiving than stick welding...

Well..... it's about time you started showing some fluxcore :D kind of funny but I do way better running downhill when I weld the plates we do to...

I have the same problem with my Lincoln. The battery cover can't be removed due to the design of my skid. I have to lift the welder every time I...

Have had to do that a few times with the 5 inch dewalts :blush: sometimes it's the only(timely) way to get a job done... and when there is a crew and...

Make sure everything is properly seated and tight on the business end of the torch.

I can't imagine going downhill with NR-211, or similar wire. You'd be racing the slag. When going uphill, it's advisable to point the gun either...

Hockey pucks work good for vibration mounts.

The worst is people using 7" disc's on a 5" grinder. Makita used to deny warranty because they could tell why the bearings went out but even worse...

Tools direct usa. Sell various adaptor shanks. I presume you are gonna connect a wet core saw to your sds drill ??? I had one that adapted a core...

I wonder how they'd do after you put them in the forge? Taking the temper out of them wouldn't hurt their functionality as a small hardy saddle...

Yeah the B&D 9inch we have you can put flat discs right on it and I think.... the makita takes em' either by flipping or something??? can't remember...

Just a note that not all grader blades are created equal... something I learned putting them on the front of the tractor blade. Some are "high...

I have an intercooler in between compressor stages and an aluminum chevy driveshaft capped off as an aftercooler, then thru a refigerated air dryer,...

I try to rubber mount it one way or another so it dosent rattle the truck any more than it has to

A mechanic once told me to use chop (hog feed) instead of Bars Leak. He said either way it's going to blow up eventually and the chop will be easier...

Those nails are rivets for each end of the friction material to get pinned down.

Welcome!

What brand and model welder?

No, of course not. :D I found the Alumweld sticks here. Similar stuff to my OP I think. ...

It's kind of funny, my oldest daughter bought a 85 Chevy 3/4 ton with a 6.2 in 2003 when she turned 16, really nice loaded Silverado edition. Four...