Activity Stream

It is not welding. It is like sponge. You can find any kind of weld defects including gas pore, under cut, less penetration, cracks...:)))

Wow, did you weld on that O/U receiver? That's something I wouldn't have the guts to do on a bet (even if I were qualified)!

Thanks for all the info local dealers sell/service Lincoln,Miller,and esab. To be honest I wouldn’t expect a lot of help from them if there was a...

What do you do when, while you're building your rotary welding table, you have to weld out-of-position? :jester: J/K ;) cool project. I've been...

Nice job on the grinder. Your horizontal powder coat oven is interesting. Do you have a build thread on it somewhere?

This explains the differences in SOOW, SEOOW and some other portable cord.... ...

https://youtu.be/-8N0y0jVAng Sent from my iPhone using Tapatalk

If it's leaking from that relief valve return it. Something inside is bad, maybe the diaphragm. Threaded fittings another story, I had one (Miller)...

Today the major brands are all world sourced. The way I understand it is as follows. Miller: "assembled in the USA" don't know the origins of parts...

This is the way to go.https://youtu.be/CrmcoXUrTHs

Here's a video showing similar use.https://youtu.be/kzC11xPmhgc

Snap ring on the end of the splined shaft. There a hole at end opposite of where the shaft goes thru that a pin goes thru a clevis that is hooked to...

Correct....total length is all that matters, not how you proportion that length.

I have had that happen on two different flow meters....one it took just a little turn and the leak stopped while the other kept leaking even after I...

I have never run an Lincoln Aspect. I just know what is possible with a Miller and I have demoed a 280DX for Miller. It is a great inverter welder....

Depends on the rod and how wet. I have cooked some moist E7018 and 310L with success. Then tried with some E9045 and suffered defeat.

Hello, good project here. I do this quite often. The way I go about this is build up the broken stud/bolt above the surface. Then weld a washer to...

There is another thread going with a similar discussion: Looking For a Tig Welder... (weldingweb.com) My opinion is HTP, Miller, Lincoln are all...

My hands are my can crushers. Feet too :drinkup:

I had my business insurance through Liberty Mutual for years, but then I had a minor claim. I am not with them anymore! I went to State Farm as I...