Activity Stream

I've been doing some reading on dual mass flywheels and per manufacturer’s instructions it is a wear item that cannot be resurfaced and should be...

oldie but a goodie ;)

The flywheel and clutch disk both look good, as does the surface of the pressure plate. The pressure plate diaphragm spring has some abnormal wear...

Where do u buy them? I onlu see 25 packs on amazon, J

I upgraded the start relay and replaced the ground with 10 foot and a better ground clamp. It great welder does all my welding. I use 0.030"...

You're probably right. All I work with is hydraulic tubing, albeit a very different animal. (Which tells me you ain't right;)) Rigid pipe is...

It is die casting Looks like a TIG job with luck . Dave

Thanks Nuff said...

Sent from my iPad using Tapatalk

i also so work with logs. Done large log cabin like structures, and a variety of timberframing, mostly with logs drug out of the woods, here in steep...

I do too. shove the big stuff in a pile, shovel it up and vacuum the poof dust. A lot faster and a lot less wear on my shoulders. I'm looking for a...

Yes I do, I welded and plumbed in that hydraulic thumb which has made life so much easier now. Only bought that backhoe for $3000, put new hydraulic...

I think he just worded it a bit awkward. He meant generally speaking, if you increase WFS (and thus amps), you also need to correspondingly increase...

definitely like that backhoe!

See here's the thing, it's not the process that is inherently better. It is always a combination of the process and the skill of the operator. No...

I prefer 5356 myself. The magnesium content provides exothermic heat during the melting and transfer through the arc. It is much stronger as well and...