Activity Stream

Build a cutting table out of a 55 gal drum cut in half long ways. Put a grate on top to hold material, all dross/slag goes into the barrel (a little...

If you can’t cut it over dirt then spread a layer of dirt out over the driveway. Lay down some underlaymeny like plastic or plywood to help make...

Guys, Thanks you both. This machine is a back burner project. I'm just seeing this thread. I'm finding that the engine runs fine in low idle...

HosFab I have traded for a Ranger 250 that is producing 34 VAC and will not strike an arc at all. The engine runs fine but very little VAC and no...

I meant examples of diagonal hole pattern. Just having an issue visualizing how a diagonal pattern will differ if the entire table is filled with...

I've seen folks try all sorts of things to get off cheap. Even a hair dryer will work for awhile if you pull out the heating element. In the long...

A company near me that was recovering silver form x-ray film was using vacuum cleaners for blowers. It worked but it was noisy and the cheap shop...

Say it isn't so. Now you will have to change your avatar. I have a pedal for that machine i can ship your way pretty cheap if the buyer is...

I realize I am about a year late to this thread but I may have the complete answer to this as I am the only one I know of that has put a Magnum Pro...

I've had a couple Lincolns and a old MM200 which were real good. I'd go to Miller or Lincoln if I were welding professionally. I'm retired and a...

You can get food grade silver solder. Wouldn't require actually melting the stainless but would be very strong and easier to control heat. Would take...

Are you or is someone else there fairly qualified in welding? I think having experienced guidance is the key. The local tech. school that does...

If anyone needs, I have an extra pedal that fits that machine. Miller RFC-23A. $150 plus shipping to US only. metalmagpie

Professionally staged to make me look like a real weldor type.... Sent from my iPhone using Tapatalk

Basically the same. Mine's an "older" model that has the bolt flange on it, but other than that... It was a toss-up between the JF#1 burner and a...