Activity Stream

From the manual: "Place Engine Control switch in the Run position for small loads." Pretty much any load on the generator side will be a small...

I prefer Torch gouging over arc gouging when what I'm gouging needs to be preheated before welding. Plus it makes a smoother cleaner gouge. But Arc...

I just died :laugh:

I would try a high settings and stick a arc. The sensor may need amperage to activate the engine solenoid. Dave

Done a little bit of scarfing at work. Nothing critical and nothing fancy. Definitely didn't have a scarfinh tip either Sent from my SM-N950U...

This is what I use for ALL my shop air. Including the hypertherm PM45 I also have an auto drain which you can see on the bottom right hand of...

Pretty cool. I have a Kawasaki ZRX Somebody cut me years ago. It was supposed to be a mailbox topper. But I don’t really like to...

I do something similar in that after welding, I spend some time cleaning the shop or putting away tools. This helps so the next time I go to start...

Nice job!

Did a lot of air arc at work yrs ago but still like scarfing better. Air arc is not something to use outdoors in dry conditions unless you have a...

Whenever I am welding grinding in my garage w/ other flammables about I try not to just finish up a weld or a cut and leave. Finish your last...

Keep moving. Some days are better than others, today is one it’s storming here so I don’t think my arthritis likes me

I did end up finishing this. Unfortunately I forgot to take pictures of it actually finished. This is the best I got

Watch a guy do that a long time ago, his name was Skip Reeves a pipe welder back in the 70’s. Didn’t know what it was called. Watched him cut welds...

my dad was in the army also. I assume that's why he was the way he was Sent from my iPhone using Tapatalk

I have been over a range from 80-150. Haven’t had a need to go higher or lower at this point

Sounds like a current transformer. What amperage are you weld with Dave

I spent over 20 years in the Army where they emphasized preventive maintenance. Almost too much emphasis at times. Nearly every Monday from 0830...

I have a commercial woodworking shop that we occasionally do welding in. Two pieces of advice come to mind. First, use a leaf blower to blow away...

Thank you sir, I hope my old man likes it just as much

I reinforced a similar trailer about 30 years ago by adding a C Channel to the outside of the existing tongue. In my instance, the C Channel was...

Best results are always consumables matched for the amps, and thickness being cut.. Also, you can fine tune the sweet spot in your table IPM...

Sadly the term preventive maintenance is foreign to a LOT of the farmers in my area. I’m fortunate that my father instilled its value to me when I...

From the Technical Manual I can't post due to file size . . . Current sensing voltage with no weld/power load: 0 volts ac; 100 ampere power load:...

Sent from my iPhone using Tapatalk