Activity Stream

A welder with an implanted pacemaker must use special insulating gloves, not work in a humid environment, and avoid working with currents exceeding...

I applaud the effort - my son has special needs too so I hunted in a "ground blind" with him (converted fish house). Got his first deer that way...

I couldn't tell you the serial numbers of the machines of hand right now but they both have 14 pin plugs on them

Anyone who stands by their spouse for that long deserves a lot of praise and recognition. It sucks that just about the time we get things figured out...

We had a truck that had enough fuel pumps put in I cut a hole in the floor of the flat bed and made a removable door to access it. As far as sammms...

Did anyone read the first post? Asking for a friend........ Sent from my moto e6 using Tapatalk

Prior to the MM200 serial number JJ407380, the Spoolmatic 1 is a direct connect that doesn't require the WC1 weld control. Effective with serial...

Have you looked online for plans?

Welcome to welding web! Thank you for your service! Enjoy retirement.

here you go Burt you could sink a metal post on each end and not attach to wall, then gate can be where you want it... I think a long slide...

Welcome to the forum!

Thanks, brother, the wife helps me spend it pretty good, blames it on the grandchildren 😁

Don’t know much about golf but a little about welding 😂

Absolutely, thanks

Are you using tubing, I'm assuming from your description. Mig with .025 wire would be my recommendation based on experience. Tig would be ideal but...

Digikey in stock $155 ea. https://www.digikey.com/en/products/detail/nte-electronics-inc/NTE5582/11649244?s=N4IgTCBcDaIAQDkAqBRArGgHBAugXyA ...

Not that unusual to pull a bed to work on a fuel pump/tank Samm. Our son - and fellow member Brink M.E. - recently had to replace the in-tank fuel...

Weather has been obstinate in our attempts to repair the broken box on my son's truck as well... ...

Gord - welcome to the forums. Can you tack on bands? You mention that your parts are going to be butt welded. I assume they are going to be TIG...

Better than I can do. If it's round, I just walk away.

Handy little boom. Like the fact that you can tilt stuff without any balance problems. Was pretty crucial in the bed takeoff. Power wash...

I personally use purple, it is in my opinion the best jack of all polarities. I only run purple because my guys loose stuff and between the trucks...

I've come to the conclusion the OP came here looking, not for advice, but an argument. Upon reading his qualifications he shouldn't need advice...

Great looking totem. I vote for the clear coat or let 'er rust if that bakes yer biscuit!!