Activity Stream

Please post a link to your thread on the other forum. -Don

I started my own thread on another forum (heavy equipment forums), going on a year July 1st and it has 98 pages of my adventures. Never thought I did...

It would have to have compromised the actual orifice to make a difference, IMO. Is the liner replaceable on the gun? Have you ran it hot and then...

Honestly rather not flux core or stick weld due to fumes they put out. I have problem from burn pits in Iraq, but I'm outdoors welding in which I...

Ramzee, Here is the thread. He did the footpedal mod on the exact unit I sold to him :laugh: Adding a foot pedal to the HF TIG welder ...

I used the titanium 125 on a job today. I did 1 inch square solid bar to 14g. Socket with the 1 inch inside the 14g tube. The only issue I have...

It is the new field welder using fluxcore wire for small jobs. All most need is a low cost generator and a quality mig welder for field welding. ...

Sorry to hear 👂. Dave

It's what I used to build this whole structure. Sometimes pulling it up by a rope each pole to be welded and lower down as so. Only got about about...

Do you do overhead TIG Welding? Dave

Didn't read all the responses but am taking long acting Hydromorphone (8 times stronger than Morphine) 9mg twice a day and can take up to 3 1mg...

I use fluxcore it goes in the trash can. If you solid wire it will work for tie wire. Dave

The drill press has 1,000 of down pressure for drill bit. I typically pick by head. I also have chain to table to hook for safety. Any photos 📸...

Looks great Like the portable welder too. Dave

I've noticed exactly that with the wander. I'm going to work on picking up the speed a bit. I kinda think moving slowly may be part of my...

Ramzee, take tapwelder's advice. Reading between the lines, I suffered from the same thing trying to do my headers. I didn't practice enough...

I'd use 7014 before 6013 and it's good to learn how to burn 7018 and 6010/6011. 6013 often get slag entrapment and are basically only good for sheet...

a little bit of arc wander comes from prep of tungsten, very little from clean weld surfaces, and most of the arc wander comes from too low of an...

It takes more skill to a torch for most welding and brazing. With TIG you have a foot control for heat control on torch you do not. I have not...