Activity Stream

dating short women Kansas City city, Missouri >>>Write only if you are serious! Rori.Age 22. My new photos and sexy videos here.Click!Write only if...

LOL I don't reckon that's 100% accurate. The thing is, people only like to remember the highlights. Whether that be good or bad, I guess that might...

Surprised y’all have hay to cut. It better get to raining fast in North Georgia if I’m going to get the JD 435 out for a 2nd cutting this year. Not...

Welcome aboard, Oduah!

Meant to edit... not quote my own post.

Well... OK, say you're using a wheel that cuts better on the rim than the sides. You make a plunge cut and it starts to veer off (or you hit a hard...

Few questions guys, My machine has a 950uf 75vdc cap in it which is shorted I ordered a replacement but the serv manual says its a 100uf 75vdc, was...

Bad wheel. Not bad wheel. Sent from my Lincoln Buzzbox using Tapatalk

Examples of both please?

Q1: did you swap out the consumables for the gouging consumables? Q2: If you did swap out the consumables for the gouging versions, is there a...

The THWN or THWN-2 is not even water proof. The proof is how many I have pulled out of rigid pipe installed outside because they were shorting out to...

Moto, it should be your, not you're, AND it should be better THAN his, not better then his, I can routinely get 25 and can get 28+ if I watch my...

The cab side mounts were done with drywall anchor and stainless screw and washer. I had to punch out a 1/2" hole to fit it though but it didnt work...

Welcome!

I finished the tank this week, just before going camping. I took some tools along and finished the wiring at the campground. I put 10 gallons in the...

I'm jealous! The trade school I went to had some Harrison lathes but the teacher liked the Standard Modern lathes they had better.

A Hypertherm rep. demoed a PM 85 at a welding supply I worked at. He said I made an excellent gouge at lower amps. Turning the machine up was much...

Nothing wrong with solid wire. I have found E70S-6 works best when I work in machine shops for farm equipment. But my line of work and shop I had...

There is a huge difference between a good chop saw blade and a poor one.

It’s just what Diesels do when u floor them. And that eco diesel was probably a lot lighter the youre truck too and possible upgrades. Asked a guy...

If I had a choice I would use solid wire.

. Once I get to make some cuts with the Benchmark High Performance wheel, I’ll post how they perform.

Yes, but I do not think this is the case. No offense to the OP, if he was already proficient doing so, he would be doing so. :) That's why he...

My pics are easier from a PC. I use 6011 for this.

I made a 6sec video of the problem but don't know if it can be attached to this post.

Printing only ½ messages is wrong. My rest of the full statement

Didja watch the dood when he went to the Portapotty, and did he take the feeder in there with him????? He mighta been pulling your leg. Never know...

The thing FALSE is your statement. Dave

Yabutt.....................stick welding makes for very solid welds when your wire welder isn't up to the challenge. It's like insurance, and you...