Activity Stream

Are you cutting down steel, or have a source for ready made? I really like the built in breakout tools.

Not when you step on them in the dark.

You would think the Canadian in the crowd would have recognized those, but I've used them. Enjoy the bicycle stage while you can... cars have...

those are plastic traction mats for dealing with mud in the winter...

It's become way less rural around here too. Too many people moving in. The old timers sell their land either in bulk, or parcels........then all...

I think they're pretty liberal about farm equipment here too. https://law.justia.com/codes/oklahoma/2014/title-47/section-47-11-406/ I used to...

I'm looking at the bicycle and the checkerplate on the ground... I don't think I've ever seen it that coarse before...

got the drill rig tower in place and the traveling cylinder pin driven in. now I need to bolt up all the slides hook up all the hoses fix the ones...

40 years ago we would move harvesters early mornings. sunday if possible. Always with a pilot car, lights, and wide load signs Today.... not...

Excellent, thank you for the sources. I contacted the lady at Logan and I'll swing by there this coming week. I made note of the other two.

Dave....... The best way to measure inside bore diameter is using a snap gauge aka telescoping gauge. ...

My opinion on out of spec farads in caps is : it's ok if you have extra uFarads for start cap but for run cap it's more critical to to use Run Cap...

Thanks, Phil. I will look into them.

So, you have a serious limit on farm equipment width in Oklahoma? In my state the limit is whatever you can move within reason up to 20' wide. But...

There's no provision for hydraulic cylinders to lift the rakes. Never was. It's my guess that people were able to purchase rakes that fully raised,...

That's a bargain for all the tooling! Did you already sell the shaper? I'm not sure why, but I really want a shaper!

But...if Sammm is already a Century old and that customer happened to be even older ...