Activity Stream

Sounds like I have a good machine therefore I will be keeping my Hobart 187 MIG. Yes I do have Primeweld 225x TIG and was considering getting rid...

I have drilled commercial glass blocks and turned them into spice jars using a 1" diamond core bit and the Eibenstock wet core drill. You just have...

In my case they don't begin until 2 or three AM, then whatever stupid song I last heard runs through my brain. Often until daylight.

How about a couple small silver-solder tacks on the back side? Sent from my iPad using Tapatalk

My theory: Some old ladies are lonely & bored. I doubt they only intend to waste my time, or drive me crazy. I do believe there is no chance I could...

Has gravity failed? I test it here all the time... but it still makes things go down... I would probably leave it as simple is elegant Sent...

Yes was beveled Sent from my LGL455DL using Tapatalk

So today I came across this bottom hot cut tool. I had put it aside to clean up years ago and had forgotten about it. The head was badly mushroomed...

How much does cymbal extend above arm ? What about drilling 1/8" holes and sticking a 1/8"pin through ? Or a "U" shape rod that will go in hole with...

Im void of deliberations. I get stuck with endless repetitions of the guitar solo from the last song I heard before I close the coffin lid. ...

The thing that always annoyed me about the twist lock style is that if you get a stuck rod you can’t just quickly release the clamp at least not as...

Welcome to the forum!

Thanks, guys. Welder is ready to go once again!! Unfortunately, I had to leave town for the weekend, but it wouldn't have mattered anyway bc I...

I wish. At least then it would be clear what they wanted. This one was a doozy Sent from my SM-G930V using Tapatalk

Does it involve western union money orders? and refunding the difference? :laugh:

I can't find my ideal multimeter.... do you know how I can still change the fuses???

Over the years I have used Tweeco or the knockoff Tweeco brands but I have also use some of the Lincoln brand clamp style rod holders.

I use the clamp style. Mostly because that is what work buys. At home the same. I know some in the trades might use the twist lock and bend the rod...