Activity Stream

My wife had colectomy several years ago because of cancerous lesions. Completely removed her colon rebuilt everything from her small intestine. She...

In a home/hobby shop? I doubt it... but you never know. weldors wear them all the time professionally. But they are pretty pricey $$$ for...

Yeah, thanks grandpa.... Also, thanks for assuming everyone on this board is an idiot. :rolleyes: There are a LOT of talented people on this...

Does anyone wear a respirator while welding?

No boat, but Seth & I got lunch in Rutland, pulled into one of 20 vacant stores on Main Street Rutland to eat it. A man in an electric wheelchair I...

When you lost your license due to a DUI but still want to go fishing. Sent from my SM-G996U using Tapatalk

I always used to say........be the puddle........be the metal. Why should you be any different. As long as you know what you're lookin' at, and it...

Yes, that is a can of gasoline:laugh::laugh::laugh:

You cannot just go on the internet and understand a cathode ray tube and the reason is that they reversed the accurate markings Benjamin Franklin put...

Canadian. Tank division. Sent from my iPhone using Tapatalk

I've never really considered heat input when I do it. I only work with mild steel........which has a low carbon content. I dunno if arc...

Sorry to here. My store my doctors test me for everything good news I did not have any problems. The did find a lot of back injuries lost...

Which Army? That makes a big difference.

Which easily verifiable information do you not agree with? Sincerely, William McCormick

From the manual: "Place Engine Control switch in the Run position for small loads." Pretty much any load on the generator side will be a small...

I prefer Torch gouging over arc gouging when what I'm gouging needs to be preheated before welding. Plus it makes a smoother cleaner gouge. But Arc...

I just died :laugh:

I would try a high settings and stick a arc. The sensor may need amperage to activate the engine solenoid. Dave

Done a little bit of scarfing at work. Nothing critical and nothing fancy. Definitely didn't have a scarfinh tip either Sent from my SM-N950U...

This is what I use for ALL my shop air. Including the hypertherm PM45 I also have an auto drain which you can see on the bottom right hand of...

Pretty cool. I have a Kawasaki ZRX Somebody cut me years ago. It was supposed to be a mailbox topper. But I don’t really like to...

I do something similar in that after welding, I spend some time cleaning the shop or putting away tools. This helps so the next time I go to start...

Nice job!

Did a lot of air arc at work yrs ago but still like scarfing better. Air arc is not something to use outdoors in dry conditions unless you have a...

Whenever I am welding grinding in my garage w/ other flammables about I try not to just finish up a weld or a cut and leave. Finish your last...