Activity Stream

Thanks for the excellent response, Dave! This looks interesting. Maybe perfect for my purposes. I’ll try to follow up on my decision and experience.

How far is your stickout. Should be 3/16 tops. Remember half the cycle you are pulling contamination off the surface and it has to go somewhere.

I finished the body work and got the bed back on. Still need to find a door. The local pick n pull has one, but i need to look at it to see if its...

I don't have a 350MP but I do have a 210MP. I would guess that it works in a similar manner. In CC mode (stick-TIG without a pedal) I set the amps...

My experience here, having used both types of torches, standard / turbo, the turbo is definitely hotter and much louder when in operation. Therefore...

A lot of people including myself will build something out of a steel square corner tube rather than a structural rounded corner tube, either because...

Excellent! Thanks for the prompt response. I'll get on it this week. This site is a font of useful information. Willie B, I've seen your...

There is a reason you see A/C guys silver brazing refrigerant lines with oxy/acetylene. A turbo air/acetylene you would melt the valve before you got...

An extruder can make you anything you like if you are ordering enough, that is why I would not just blanketly say all architectural is 6063 and all...

Always start with contacting miller. They are very good about responding to their tech emails.

It is looking great. Sincerely, William McCormick

It came with the MSDS Sent from my SM-G930V using Tapatalk

Which Hobart model did you use?

If they want it their gonna get it. Best bet is to keep them unaware of the equipments existence. Kill switches on equipment Battery isolators...

Nice. Also, a weight for holding down plans.

Make tool look ugly and broken down. Dave

Nice job Willie

Those and the long C clamps were pretty much gathering dust until I built the table.

A guy at work has the 4.5” chief and it is smooth but extremely heavy and the throttle will act like it’s sticking even tho it’s not being pressed...

1/4" slices, lightly browned on sourdough with a thin slice of pepper jack cheese, Mayo and stone ground mustard to taste and it's good to go.

That SPAM looks inert??? there also should have been a chart on the can showing just how mush is needed for the typical welder meal :D

I own both the HF folding table, and the Northen Tool table. Of the two, I prefer the Northern Tool and the assortment of clamps that come with it....

Okay thanks... So to energize the torch, one needs to turn the knob to turn on and off??? A triggering device??? Can that be made or is that a...