Results 1 to 4 of 4

Thread: Miller dynasty 200dx

  1. #1
    Join Date
    Mar 2017
    Posts
    10
    Post Thanks / Like

    Miller dynasty 200dx

    I have an older dynasty dx and the machine still Welds great however in the fold down door where the control buttons are the button that controls the output from on to remote etc.... Is non functional... Every now and then I can push it 40 or 50 times and it may change lol. I've been told this machine was made prior to some type of change they made to this control board so they no longer even service it. However like I said the machine still Welds great and if I'm stick welding with it I just clamp the foot pedal all the way down (since the default output is remote)and it works fine. That being said I think the only issue is this button or something if that nature so my question is.... How would one go about checking this out and repairing it? Thanks in advance.... Dale

  2. #2
    Join Date
    Mar 2010
    Location
    Ceres, California
    Posts
    3,668
    Post Thanks / Like

    Re: Miller dynasty 200dx

    Get a remote control box. has a on/off switch and a control pot. Some people call them ditch boxes.

  3. #3
    Join Date
    Mar 2017
    Posts
    10
    Post Thanks / Like

    Re: Miller dynasty 200dx

    Gotcha..... Haven't thought about that

  4. #4
    Join Date
    Mar 2017
    Posts
    22
    Post Thanks / Like

    Re: Miller dynasty 200dx

    Do you have a picture?
    Could it be the actual button is just a surface mount button behind a printed overlay?
    If it's made that way a decent electronics shop could probably swap out the button for a small amount of money.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,606,520,354.10755 seconds with 13 queries