Invertig 221

[haksa]

Hi, I just bought an Invertig 221. I have a Pro pulse 300, I'd like to put them together on one cart. I've already experienced what high frequency can and will do to electronic devices nearby. Cost $800 to replace a board on my brand new LN 25. So can I ground the machine and be safe, or separate carts?
Haksa

[John T]

Have you contacted HTP to see what they have to say?

[haksa]

not yet

[Oscar]

I have my Invertig right next to my ProPulse 300. Never had any issues, although I suppose that doesn't answer your question. The machine case is grounded via a short ground wire on the inside, granted it is not a separate actual ground path, but still "eventually" is connected to ground.

[haksa]

Thanks Oscar, your th

[TJS]

Look up Jimbo's Garage on YT and IG. He has like 3 or more HTPs together on one cart. He never said he had an issue either.

[DannyPhilips]

Hi, I just bought an Invertig 221. I have a Pro pulse 300, I'd like to put them together on one cart. I've already experienced what high frequency can and will do to electronic devices nearby. Cost $800 to replace a board on my brand new LN 25. So can I ground the machine and be safe, or separate carts?
Haksa

How in the end did you decide to organize your equipment on one frame?

[haksa]

Hi, I been to busy to build a dual cart, that will come later this winter. I was worried about the HF burning up the board in my Pro pulse 300. As I said earlier I had a costly lesson.

Haksa

[Oscar]

How do you like that 300? Its a beast huh? have you ran pulse steel on 92/8?

[haksa]

Hi, Yes I have, with just 75/25. As far as the welder goes, like I told Pete at HTP, It's the best, smoothest, most adjustable machine I've ever used. I've been around a long time.

haksa

[Oscar]

Hi, Yes I have, with just 75/25. As far as the welder goes, like I told Pete at HTP, It's the best, smoothest, most adjustable machine I've ever used. I've been around a long time.

haksa

IMO it's a bit "smoother" on 92/8, but that's just my take on it.

[haksa]

I can't see how it could be smoother than it is. But I don't need a bunch of bottles around.

[Jawslandshark]

The PP300 is one of the best all around mig welders I have used as far as arc quality thick and thin, both steel and aluminum. For steel I run C10 on short arc and pulse. The machine has plenty of power.

[tackit]

Can anyone show examples of spray arcing beads made with .030 wire and 98/2 shielding gas on a PP 220 MTS machine?

[tackit]

Sorry wrong machine.