On/Off Switch for Lincoln Ranger 8 Welder

[smilezrcool]

Does anyone know the part number for the on/off switch, for the Ranger 8 welder? The model number is 10373. It has the 16hp Onan motor.

[ronsii]

Here is the start button(#S13146-1)?


https://weldingmart.com/lincoln-elec...utton-s13146-1

[ronsii]

Ooops read your post wrong

[ronsii]

They be proud of them thar switches

https://weldingmart.com/lincoln-elec...-spdt-t13562-1

Like most things looks like you can get it cheaper.... just make sure it's the right one!!!
https://www.ebay.com/itm/Lincoln-Ele...sAAOSw2Zld5-Jc

[OPUS FERRO]

smilezrcool

Does anyone know the part number for . . .

Once you have the # - what are you going to do with it . . . ?


Opus



.

[smilezrcool]

Thanks for the information. Where did you find that parts list? That is what I need. Thanks.

[smilezrcool]

The reason I am asking about the on/off switch. I purchased the Ranger 8 a couple of weeks ago. The previous owner broke the on/off switch and replaced, not sure if correct one but the switch turns the welder off. My question, the ammeter gauge on the face off the machine never shows positive charge. It is always on negative side of zero, even when I start the machine but alternator is charging. With machine running I have 13.5 volts on battery. I noticed in the electrical schematic of the welder, the on/off switch is connected to the ammeter circuit. Not sure if this is why the ammeter gauge never shows positive charge. Thanks.

[smilezrcool]

I am posting the electrical schematic of the Ranger 8 welder, with the Onan engine. Do you think if the on/off switch is installed incorrectly, would this cause the ammeter to register incorrectly?

[ronsii]

The reason I am asking about the on/off switch. I purchased the Ranger 8 a couple of weeks ago. The previous owner broke the on/off switch and replaced, not sure if correct one but the switch turns the welder off. My question, the ammeter gauge on the face off the machine never shows positive charge. It is always on negative side of zero, even when I start the machine but alternator is charging. With machine running I have 13.5 volts on battery. I noticed in the electrical schematic of the welder, the on/off switch is connected to the ammeter circuit. Not sure if this is why the ammeter gauge never shows positive charge. Thanks.

Just go to lincolns service site https://lincoln-is-viewer.ptcmscloud...ery/#/V=2/home

[smilezrcool]

The link you gave me will not load.

[OPUS FERRO]

smilezrcool

Once you have the # - what are you going to do with it . . . ?

They be proud of them thar switches

I recently replaced a Lincoln switch - same price.

I happen to know the 'Control House' the regional
Lincoln authorized repair depot buys their parts.

Switches are not proprietary - out the door 14.00$

Shop around . . .


Opus



.

[ronsii]

The link you gave me will not load.

Oh... they got one of them funky sites...

you'll have to start at lincolnelectric.com https://www.lincolnelectric.com/en-u...s/default.aspx and work your way to parts/service...