Results 1 to 4 of 4

Thread: New down pipe

  1. #1
    Join Date
    Dec 2005
    Location
    Sacramento
    Posts
    85
    Post Thanks / Like

    New down pipe

    My buddy is doing a motor swap in his Toyota ae86 and we had some down pipe issues. It was going to run into the steering shaft. He really wanted to do all pie cuts for the bends, so twenty-six sections later.



    It would have been nice to TIG it, but I wanted it done today...lol
    "If you live in Sacramento you have seen my work."

  2. #2
    Join Date
    Feb 2011
    Location
    va beach
    Posts
    34
    Post Thanks / Like

    Re: New down pipe

    look good..would of been nice to see it tig

  3. #3
    Join Date
    Jun 2010
    Location
    Louisville, KY
    Posts
    417
    Post Thanks / Like

    Re: New down pipe

    I think that, cleaned up, that will look pretty good. It's more welding than I like to put on it, but the customer gets what they want.

  4. #4
    Join Date
    Feb 2006
    Location
    Back in HB, close to my boys!!
    Posts
    4,666
    Post Thanks / Like

    Re: New down pipe

    Jeez, I would rather buy bends from McMaster Carr, etc. and cut and fit them. It takes so much less time, you save a load of money on the labor. Also, less exhaust leaks and cracks over time.....
    And then, after so much work...... you have it in your hand, and you look over to your side...... and the runner has run off. Leaving you holding the prize, wondering when the runner will return.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,628,130,697.24640 seconds with 13 queries