Originally Posted by
KMA
Maybe the synergic mode issue is a combination of 2 or more of the following:
1. Actual voltage is roughly 1 volt or so higher than display setting
2. Actual wire speed is roughly 25% faster than display setting
3. Voltage/wire speed relationship doesn't always match other calculators/settings charts
I haven't done much testing, but my guess is that if you set your wire feed speed based on your findings, then manually change the voltage (also using your measurements), it should track from that point on (at least over a certain range). You could try it and check it against your data to see if the translated values match what you're expecting. If so, you can save the settings in a memory location, then each time you want to use synergic mode, you would chose that memory slot as a starting point. Of course it might be just as easy to use standard mode. I think these things aren't an issue in standard mode because we're not expecting the machine to figure anything out for us, so we're prepared to test and adjust as necessary to get it right.
Thanks,
Kevin