Results 1 to 4 of 4

Thread: What do I need to do to make my Miller Shopmaster 300 TIG weld?

  1. #1
    Join Date
    Feb 2016
    Posts
    2
    Post Thanks / Like

    What do I need to do to make my Miller Shopmaster 300 TIG weld?

    Hello, sorry for my ignorance. I'm trying to figure out what I need to put my output levers on, and where my electrode and ground cables go so I can TIG with my Miller Shopmaster. I have a ground cable, Electrode, Gas and a TIG torch. Thank you and once again, sorry I am so nave.

  2. #2
    Join Date
    Feb 2016
    Posts
    2
    Post Thanks / Like

    Re: What do I need to do to make my Miller Shopmaster 300 TIG weld?

    Thanks, but I figured it out. I had it backwards at first and of course, it wouldn't arc. Then I had it the right way and somebody told me it didn't go that way. After signing up here, I went back and tried after that person walked off. I hope I learn to TIG faster than I learn how to trust my instincts before someone's opinion.

  3. #3
    Join Date
    May 2011
    Location
    Andover, Ohio
    Posts
    2,568
    Post Thanks / Like

    Re: What do I need to do to make my Miller Shopmaster 300 TIG weld?

    Welcome to the forum.
    Lincoln A/C 225
    Everlast P/A 200

  4. #4
    Join Date
    May 2008
    Location
    Orange, TX
    Posts
    17,392
    Post Thanks / Like

    Re: What do I need to do to make my Miller Shopmaster 300 TIG weld?

    Do you have the unit's Operator's Manual?

    If not, go here https://www.millerwelds.com/support/manuals-and-parts, enter the eight character SN (two letters followed by six numbers) to download it.
    MM200 w/Spoolmatic 1
    Syncrowave 180SD
    Bobcat 225G Plus - LP/NG
    MUTT Suitcase Wirefeeder
    WC-1S/Spoolmatic 1
    HF-251D-1
    PakMaster 100XL
    '68 Red Face Code #6633 project
    Star Jet 21-110

    Save Second Base!

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,632,257,735.33136 seconds with 13 queries