Results 1 to 1 of 1

Thread: Miller Diversion 180, showing off a few weld

  1. #1
    Join Date
    Oct 2015
    Location
    Oregon
    Posts
    27
    Post Thanks / Like

    Miller Diversion 180, showing off a few weld

    Feel free to move this if it's in the wrong area. Wasn't sure where to put it.

    I bought the Diversion 180 a while back and have just got around to welding some aluminium. For the most part I was impressed for its size. On the 1/4" flat stock it takes a bit to get a puddle going. I have to admit I haven't welded aluminium in about 15 years and I didn't put a lot into cleaning the material (attempt at an excuse for crappy welds).

    The flat stock is 1 1/2 x 1/4 and the tubing is roughly .060 welded to 1/8" sheet/plate.

    I bought the diversion 180 so I had a Tig around the house just in case. I would have loved to buy a bigger machine but funds were tight as I bought a Millermatic 211 and Hypertherm 30xp the same week. I plan on only do light fabrication. Mostly little projects for my truck(rock sliders, bed rack, solar duel battery setup) and stuff around the house. Questions or critiquing encouraged.



    Name:  image.jpg
Views: 210
Size:  32.1 KBName:  image.jpg
Views: 200
Size:  29.2 KBName:  image.jpg
Views: 205
Size:  30.6 KBName:  image.jpg
Views: 206
Size:  26.0 KB
    Last edited by TRENT; 04-22-2016 at 12:52 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,642,483,885.82326 seconds with 12 queries