Up-Graded Tig Welder

[acourtjester]

I up-graded my Everlast Power Tig 250 EX to the 250 EXT model, built a new cart and water cooler for the buyer, and here it is.

[dmcnally]

built a new cart and water cooler for the buyer, and here it is.

That looks nice. Are you sure you want to sell it?

Dave

[LtBadd]

Nice looking cooler

[Larrysmachine]

Nice, looks like it is doing 100mph setting still!

[TJS]

Looks good Tom. Where did ya get that cooler tank from.

[Munkul]

nice cart. Could do with some sheet metal over the top of the cooler components to shield them and perhaps store stuff on, but that could be the new buyer's responsibility

[acourtjester]

I am selling it because I bought the 250 EXT model (digital version new with the mixed pulse option). The new tig is on my other cart with a Miller Mig above the water cooler assembly and the tig on top very similar to this cart. That cart had 2 cylinders 1 argon and 1 c25 for the Mig.
I bought the stainless tank on eBay it is a air tank for air bag setup on autos, 3 Gal, the one I wanted had less ports on the top.
https://www.ebay.com/itm/3-Gallon-Po....c100752.m1982

[swift~six]

What motor and pump is that on the cooler? Looks great!

[SlowBlues]

Nice! I would throw some plexi glass around the water cooler (just bc of dust etc) but I think it looks great. The buyer is going to be more than happy i'm sure

[acourtjester]

Ok here is the "Hot Scoop" on the parts all bought for eBay.
Best motor deal
https://www.ebay.com/itm/CENTURY-CB2....c100008.m2219

best pump Procan only I had a bad pump from Fluide****
https://www.ebay.com/itm/CENTURY-CB2....c100008.m2219

need this clamp to connect pump to motor
https://www.ebay.com/itm/PROCON-PUMP....c100008.m2219

type of hose clamps I used but you need to get the size you need these are 14.5 (0.570") I also used 13.5 you need a tool to install
https://www.ebay.com/itm/Oetiker-Cla....c100752.m1982