A couple more...
***Yes, I did see apewrangler's WTB post below....sent him a PM a week ago and never heard back***
A local powder coating shop closed down and I was able to get a couple of things from them, to include this Spoolmatic 1 and the WC-1 controller. With some help from the folks here I was able to pair this combo up with my ancient MM35S to test out and everything seems to be in order....welds just fine even with my very limited spool gun experience.
The fuse cap disappeared while I was transporting it, so I bought a new one, but it turns out I should have gotten a shorter fuse cap...this one is a bit too long and only works with the longer fuses. I guess they originally used the shorter cap with the shorter fuses, but it works fine as is. The insulation on the wire for the 4-pin going from the gun to the WC-1 is pretty dry and has some cracks and a few bare spots. I covered them with electrical tape, but would either replace the wire entirely or put shrink tubing over it if I was going to keep it.
$300 plus actual shipping via PayPal friends and family (or cash if you're local in the metro Detroit area).
Last edited by G-ManBart; 11-23-2019 at 06:29 PM.
Check out my bench vise website:
http://mivise.com
Miller Syncrowave 250DX
Millermatic 350P with XR AlumaPro
Miller Regency 200 with 22A feeder and Spoolmatic 3
Hobart Champion Elite
Everlast PowerTig 210EXT
A couple more...
Check out my bench vise website:
http://mivise.com
Miller Syncrowave 250DX
Millermatic 350P with XR AlumaPro
Miller Regency 200 with 22A feeder and Spoolmatic 3
Hobart Champion Elite
Everlast PowerTig 210EXT
***sold***
Check out my bench vise website:
http://mivise.com
Miller Syncrowave 250DX
Millermatic 350P with XR AlumaPro
Miller Regency 200 with 22A feeder and Spoolmatic 3
Hobart Champion Elite
Everlast PowerTig 210EXT