Results 1 to 3 of 3

Thread: Spoolmatic 1 and WC-1

  1. #1
    Join Date
    Sep 2016
    Location
    Detroit, Michigan
    Posts
    878
    Post Thanks / Like

    Spoolmatic 1 and WC-1

    ***Yes, I did see apewrangler's WTB post below....sent him a PM a week ago and never heard back***

    A local powder coating shop closed down and I was able to get a couple of things from them, to include this Spoolmatic 1 and the WC-1 controller. With some help from the folks here I was able to pair this combo up with my ancient MM35S to test out and everything seems to be in order....welds just fine even with my very limited spool gun experience.

    The fuse cap disappeared while I was transporting it, so I bought a new one, but it turns out I should have gotten a shorter fuse cap...this one is a bit too long and only works with the longer fuses. I guess they originally used the shorter cap with the shorter fuses, but it works fine as is. The insulation on the wire for the 4-pin going from the gun to the WC-1 is pretty dry and has some cracks and a few bare spots. I covered them with electrical tape, but would either replace the wire entirely or put shrink tubing over it if I was going to keep it.

    $300 plus actual shipping via PayPal friends and family (or cash if you're local in the metro Detroit area).
    Attached Images Attached Images      
    Last edited by G-ManBart; 11-23-2019 at 06:29 PM.
    Check out my bench vise website:
    http://mivise.com


    Miller Syncrowave 250DX
    Millermatic 350P with XR AlumaPro
    Miller Regency 200 with 22A feeder and Spoolmatic 3
    Hobart Champion Elite
    Everlast PowerTig 210EXT

  2. #2
    Join Date
    Sep 2016
    Location
    Detroit, Michigan
    Posts
    878
    Post Thanks / Like

    Re: Spoolmatic 1 and WC-1

    A couple more...

    Name:  IMG_8559.jpg
Views: 149
Size:  113.6 KB

    Name:  IMG_8568.jpg
Views: 151
Size:  106.7 KB
    Check out my bench vise website:
    http://mivise.com


    Miller Syncrowave 250DX
    Millermatic 350P with XR AlumaPro
    Miller Regency 200 with 22A feeder and Spoolmatic 3
    Hobart Champion Elite
    Everlast PowerTig 210EXT

  3. #3
    Join Date
    Sep 2016
    Location
    Detroit, Michigan
    Posts
    878
    Post Thanks / Like

    Re: Spoolmatic 1 and WC-1

    ***sold***
    Check out my bench vise website:
    http://mivise.com


    Miller Syncrowave 250DX
    Millermatic 350P with XR AlumaPro
    Miller Regency 200 with 22A feeder and Spoolmatic 3
    Hobart Champion Elite
    Everlast PowerTig 210EXT

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,624,570,974.76982 seconds with 12 queries