Re: I MIG 200E work clamp cable
Any welding supply store sells cable. You don't need a new connector.
I guess you may not realize that the DINSE connector comes apart and the cable is held in by a set screw? This is S.O.P. if you wan to lengthen your cables. Pull your boot off the DINSE and undo the cable. Put a lug on the other end for the work clamp (avaialble at any local welding supply store as well) and reattach it.
Dinse 25 cables are only 3/8" (nominal, but not exact), not 1/2.
By the way, the rule of thumb is no more than 2/3 the length of your MIG gun for work. This is fairly standard recommendation throughout the industry.
Esab Migmaster 250
Lincoln SA 200
Lincoln Ranger 8
Smith Oxy Fuel setup
Everlast PowerPlasma 80
Everlast Power iMIG 160
Everlast Power iMIG 205
Everlast Power iMIG 140E
Everlast PowerARC 300
Everlast PowerARC 140ST
Everlast PowerTIG 255EXT